Many of Leister’s tools utilize a lock pin to hold the nozzle in position during welding and cooldown. The lock pin is designed to snap if excessive force is put on the heater in order to prevent more expensive damage to the tool.

The most common reason for a lock pin to bend or break is the tool being lifted or carried incorrectly. The correct methods of carrying the tool are with both hands under the frame, or with one hand under the frame and the other holding the black carrying handle.

In this guide, parts will be referred to using the numbers indicated in the VARIMAT V drawing below. As an example, see lock pin (79).

Tools needed:

• 3/32″ punch and 1/4″ punch
• Hammer
• 7/64″ steel dowel (a 7/64” drill bit is a great substitute and is more commonly owned)
• Long-nose vise grip
• Tools which may be needed:
• Type 7WR vise grip
• Small flat screwdriver

Method:

Punch out the roll pin (76) with the 3/32″ punch and hammer. Be careful not to hit the side of the trigger or the tool holder (146) with the punch. While keeping a finger on the spring (77) so that it does not fly away, hold the trigger (78) and pull out the punch. Pull out the trigger and the spring together.

Remove the lock pin(79):

If the lock pin is bent, pry it out with a vise grip.

If the lock pin is broken and some of it is stuck in the hole:

Tip the tool so that the nozzle points upward as steeply as possible. Rock the heater up and down.

Pull at the broken piece of lock pin with the small flat screwdriver to draw it out.

​If you are unable to remove the entire lock pin please send the tool in for repair at PLASTRAL.

Install the new lock pin with the flat middle section facing where the trigger will be.

For the UNIROOF AT or ST the flat section is off-center. The new lock pin must be installed with the flat section closer to the trigger.

Install the spring and trigger together:

Ensure that the trigger fits into the flat section of the lock pin, and that the hole in the trigger is in line with the holes in the tool holder.

Hold the trigger in place and feed your dowel (or the blunt end of your drill bit) through the lower hole in the tool holder, through the trigger, and partway through the upper hole in the tool holder. This will keep the trigger in place and aligned while you re-insert the roll pin.

Hold the roll pin with the clamped vise grips with very light pressure so that the roll pin is not crushed. This works best if the vise grips are positioned a third of the way up the roll pin.

Feed the roll pin into the upper hole of the tool holder while twisting it back and forth with the vise grip. Adjust the vise grip as necessary. It can also be helpful to make slight positional adjustments with the trigger during this process, to reduce resistance on the roll pin.

If the roll pin stops making forward progress, tap it gently with the hammer. Be careful not to hammer the roll pin against the side of the trigger or tool holder (on the inside). It can help to press forward on the trigger while tapping the roll pin.

When the roll pin is so far in that the vise grip cannot grip it, carefully tap the roll pin with the hammer until the roll pin is completely inserted.